Feeder System
Designed here. Used in our own enclosures.
Made for hybrid enclosures
A feeder that lifts out to clean.
A three-piece PETG cup feeder with a permanent wall mount, removable box and separate lid. Choose a single color or mix and match.
Tell us the quantity and colors. We’ll confirm availability and pricing.
Feeder System Features
Lifts Out to Clean
The box separates from the mount, so you never scrub inside a planted enclosure.
Textured Back Wall
A diamond-textured rear panel gives feeders somewhere to sit visibly rather than hiding in a corner.
Lots of Colors
Single-color or multi-tone combinations. Match your enclosure, or do not. Up to you.
Printed in PETG
Tougher and more heat tolerant than PLA, and it takes a wipe-down without going brittle.
Designed for a purpose
Built for Hybrid Enclosures
We are firm believers in hybrid enclosures: screen top and lower front, solid PVC sides and back, clear acrylic front door. That combination holds humidity while the chimney effect keeps fresh air moving continuously.
Solid side panels are what make this feeder work. The mount screws straight to a flat PVC wall and stays exactly where you put it. No clips fighting a screen panel, no sagging under the weight of a box full of roaches.
Important: Do Not Mount in the Top Third of the Enclosure
We strongly recommend fitting the feeder in the lower two-thirds of the enclosure, well away from UVB tubes and heat lamps.
PETG is a tough material, but sustained UV exposure and radiant heat from a basking bulb will soften and discolor it over time, and can eventually warp the fit between the box and the mount. Your feeders will also cook and dehydrate up there, which defeats the point of gut loading them.
Mounted low, out of the lamp's direct path, these will last for years.
Colorways
Pick a Color
A selection of what we print. If you want a color you do not see here, just ask. We can usually source it.
Multi-Tone
Mix and Match
Mix and match colors across the wall mount, feeder box and lid. Keep it coordinated, or use different combinations to tell your enclosures apart at a glance.
Ordering
How to Get One
Same as everything else here: message us and we will sort it out.
Tell us how many you want and which colors, and we will confirm availability and price and send a Square invoice. If you are already reserving a chameleon, we will simply add the feeders to the same invoice and they travel with your animal.
You will also find us with these on the table at reptile expos throughout the region.
Questions About Fit or Sizing?
Tell us what enclosure you are running and we will tell you whether these will work in it.